TEGRA Porcelain Furnaces

Porcelain Furnace Error Messages

To keep your device covered by the warranty, it may only be disassembled and serviced under the supervision of authorized personnel. Make sure the device is unplugged for service.

⚠PLC Not Responding 00-01-0

The temperature control unit cannot communicate with the main controller.

  • Check the lights on the temperature control unit.

  • Check the HMI (Touch Screen) connections.

  • Remove the cable and inspect it for defects.

  • If no fault is found in the cables, replace the faulty modules.

    ⚠ PLC Not Responding 00-01-2

The PLC or controller cannot be reached.

  • Check the lights on the PLC or controller board.

  • Check the connection cable with the HMI (Touch Screen).

  • Remove the cable and inspect it for defects.

  • If no fault is found in the cables, replace the faulty modules.

    ⚠ Sensor Not Found

Sensor not found. Check the wiring and the sensor. The sensor may be faulty. The main controller has trouble detecting the signals coming from the sensor. There may be a problem in the cable from the controller to the sensor or in the sensor itself. The service life of thermocouples varies depending on the material and usage. If the thermocouple has lost its shine, it is time to replace it.

  • Check the heating chamber. Look up to see the sensor. If it appears broken, you should replace it.

  • Check the cables from the controller to the sensor.

    ⚠ Under Scale Error / Lower Scale Error

This error means that the temperature reading of the thermocouple/heat sensor is negative (the number decreases as the temperature rises, or “***” is displayed as the temperature). To correct the error, reverse the cable positions. You can do this easily at the thermocouple connector. Do not change the cables on the board, because thermocouple cables also have negative and positive lines. The Red/Orange line is always positive.

⚠ Heating Not Possible

Check the Heating Element; it may be broken and require replacement.

If you notice the following:

  • Unusual smells
  • Longer than normal heating times
  • Cracks in the chamber
  • Different, unusual sounds

📞 Contact TEGRA technical support. Early diagnosis is very important.

A porcelain furnace is not just a heating tool — it is an investment in precision. With just a few minutes of maintenance a week, you can extend its service life and prevent breakdowns.

Click here to read our maintenance article.

At TEGRA we build our furnaces to be durable and user-friendly — but high performance starts with good habits.

Do you need maintenance or calibration support? Contact our support team — we can guide you in less than 10 minutes.