Articles

Sintering Monolithic, Layered, Pre-Colored and ...

The most commonly used type of zirconia for dental CAD/CAM is yttrium-stabilized tetragonal zirconia polycrystalline (Y-TZP) zirconia. Y-TZP is a very durable and strong material, making it ideal for many...

How to sinter larger loads with up to 60 - 90 u...

Not getting the same results for a single unit versus a lot of units are due to the following factors: Heat Dissipation: When you sinter multiple teeth units in the same...

Regeneration of the silica layer of the MoSi2 h...

The regeneration of SiO2 (silicon dioxide) is typically most effective within a specific temperature range. Thermodynamically, the best temperature range for SiO2 regeneration is generally between 800°C and 1100°C. Here's...

Don't discard leftover and broken zirconia blan...

Calibration / Offset adjustment in dental furnaces

Meet the calibration function of your furnace.  There is an offset/calibration setting in the settings section of all ovens. From time to time, the temperature you see on the panel of...

Starting your dental lab: why you need high qua...

 If you're starting a dental laboratory, congratulations on taking this exciting step! However, to ensure that your lab is successful, you need the right equipment, including furnaces. Furnaces are critical...