Yellow Powder on MoSi2 Heating Elements

Articles · · Ali Parlar

MoSi2 Pest Oxidation

Understanding and Preventing Pest Oxidation in Your Zirconia Sintering Furnace

If you are a dental technician working with zirconia, you have come across the yellow powder that occasionally appears on your MoSi2 heating elements and even on your restorations. This “pest oxidation” not only affects the firing; it also affects the next firing, and it burns away and disappears, which makes it very hard to notice. It is rare, but it is a problem that visits you from time to time without you knowing.

The most reliable way to catch it is a visual check of the heating elements before you fire your work. It appears as a yellow powder coating on the heating elements and can be cleaned off with a dry cloth.

What Is Pest Oxidation?

Pest oxidation is the formation of molybdenum trioxide (MoO3), a substance in the form of yellow powder, on the MoSi2 heating elements in your sintering furnace. It is a by-product of the reaction of molybdenum disilicide (MoSi2) with oxygen at high temperatures.

When Does It Occur?

Pest oxidation occurs during the cooling phase of the sintering cycle, not during heating.

While some minor oxidation can occur as the furnace heats up, the real problem begins when the temperature drops below 1000°C and continues down to 600°C. Above 1000°C, a protective silica (SiO2) layer forms on the heating elements and acts as a shield against oxygen.

However, as the zirconia sintering furnace cools, this layer can weaken and allow oxygen to enter and react with the MoSi2.

Cooling Rate: Rapid cooling increases the thermal stress on the protective silica layer, causing more weakening and exposure of the MoSi2, which makes the problem worse.

Humidity: Moisture in the air reacts with MoSi2 at high temperatures and accelerates oxidation. The most practical precaution you can take is to use your furnace in a dry environment.

Condition of the Elements: Old or low-quality heating elements, or a weak silica layer, are more prone to oxidation.

Chemical Reaction:

The resulting MoO3, SiO2 and Fe2O3 are volatile at high temperatures and condense as yellow powder on the chamber walls and the elements, including your valuable zirconia restorations.

Eliminating the Yellow Powder: Prevention Strategies

Fortunately, you can take steps to minimise pest oxidation and keep your furnace and restorations clean: Controlled Cooling: To reduce thermal stress on the heating elements, apply a controlled cooling rate, especially from 1200°C to room temperature.

Pre-Drying: Provide a low-humidity firing environment by heating not only your work but also the inside of the furnace.

Regular Maintenance: Inspect and clean your furnace regularly, including the heating elements. Replace worn elements immediately.

By understanding the science behind pest oxidation and applying these preventive measures, you can extend the life of your sintering furnace, minimise colour distortion in your restorations and, as a result, improve the quality of your work.

Detection and Prevention

Inspect the elements before firing; if there is a yellow powder coating, clean it with a dry cloth, but do not let the powder spill into the chamber. Then you can run a cleaning program to make your furnace ready for use